Installation Guide

Download Instructions
What’s in the box?

- 1 Shower Manager (Battery Installed)
- 1 Instruction Sheet
- 1 Rubber Washer (for Inlet)
- 1 Programming Magnet
Tips for Successful Use
Get the family on board!
Let everyone involved know about what you hope to accomplish by using the Shower Manager and create a reward system for when the goals are reached.
Plan ahead!
During the 5 minute reset period only a reduced flow of water is available. Only after this time has elapsed, will the Shower Manager will restart in Full-Flow Mode.
Recommended Installation

- Pulsating or massaging shower heads
- Shower heads equipped with on/off valve
- Hand-held shower heads
- Oxygen combining shower heads
- Ultra-low flow shower heads with less than 1.8 GPM
- In homes with very low water pressure (<40 PSI)
Setting the Shower Time
Note: The Shower Manager comes ready to use, pre-programmed with the 5 minute full-flow setting for maximum water and energy savings.
How to change the shower time.

Locate the magnet below and place it on the Shower Manager as shown.
Notice: The line or rasied bar on the side for correct placement of the magnet. Slowly move the magnet from the front to the back along this line until you hear 1-3 beeps. The number of beeps indicates the current time setting.
Note: The unit can’t be programmed while in full-flow, reduced-flow, or during the reset period. If the unit refuses to respond to programming, wait a full five minutes before trying again.
To change the time setting:
Repeat the placement of the magnet on the line, but hold it there until the number of beeps changes to correspond with your desired time setting.

Beep Key
1 beep = 5 minutes2 beeps = 8 minutes
3 beeps = 11 minutes
Standard Model times shown
Prepare for Use
Verify the included rubber washer is installed in the water inlet. Correctly installed, this washer provides a drip-free seal.
Optional: In the event of drips due to damaged threads preventing a good seal with the washer. It is recommended to wrap the threads on the shower neck with 2-3 wraps of Teflon thread seal tape (PTFE plumber’s tape – not provided).
IMPORTANT: Use of anything other than Teflon tape can damage the Shower Manager & void the warranty.
Troubleshooting
Installing the Shower Manager
1) Remove Showerhead


2) Attach Shower Manager
Carefully thread the Shower Manager onto the supply pipe until snug, then hand-tighten just enough to stop water leaks.

3) Replace Showerhead
Replace the shower head, being careful not over-tighten as this can damage the unit and void the warranty.
